1966-71 JEEPSTER/COMMANDO

Wire Harness, Universal 21 circuit pre labled wires

21 Circuit generic universal wire harness These wiring kits use GXL 125 high temp cross linked polyethylene jacketed wire that is grease, oil, gas, and acid resistant. Each wire is labeled every 5" its entire length so checking a circuit is easy! COLOR...

Jeepster/Commando SC-1 stripe kit, satin black

Brand new SC-1 stripe kit, full kit in satin black

Distributor drive gear, 225/231 V6

Distributor drive gear for 225/231 V6 with HEI distributor This will also fit the Delco distributor, but you will have to drill out the distributor shaft to accomodate the included larger roll pin. No drilling on HEI appliaction

Front and rear seat cover set, black with basket weave inserts

Front and rear seat covers for your Jeepster/Commando. These were mostly in deluxe Jeepsters Black vinyl with basket weave perforated center inset. These are beautiful!

Differential side gear washer, Dana 44 flanged/Dana 53

Fits Jeep: Jeep Wrangler (YJ) (1987-1995) w/ Dana 44 Rear Axle; KDX. Jeep Cherokee (XJ) (1984-1993) w/ Dana 44 Rear Axle. Jeep Comanche (MJ) (1986-1992) w/ Dana 44 Rear Axle. Fits Vintage Jeep: Jeep CJ-5 (1969-1975) w/ Dana...

Clutch for pivot ball, extended

Clutch fork pivot ball, extended .30" to account for clutch fingers that do not protruded into the throwout bearing as much as the older clutches used to. This will correct the geometry. Measures 1.80" in length.   This will not work for one-piece...

Aero tank EFI baffle - add onto tank order

This is the add on teheEFI baffle for when you are ordering the Aero 23 gallon tank. Must order tank to go with this EFI baffle in one order

Aero tank skid plate - add onto tank order

This is the add on skid plate for when you are ordering the Aero 23 gallon tank. Must order tank to go with this skid in one order

Hose line fitting, -3AN Male to 3/8"-24, Female

Hose Line Fitting, 3an Male to 3/8"-24, Female   These are commonly used for front brake line fitment issues. Most stainless extended brake line kits are made for 11" brakes which typically have 1/2"-20 flare nuts on the hard lines...

Oil pickup tube/screen 225/231 V6 or 252/300/340/1968 350 V8, 5/8"

Oil pickup tube/screen 225/231 V6/252/300/340/1968 350 V8, 5/8" High quality original replacement and performance oil pick up tube assemblies. Recommended for most rebuilds. Many early small and big block Buicks used 1/2” oil pick up tubes, this...

Rear bed floor hat channel, 1966-73 Jeepster/Commando

Cargo area brace replaces the original brace that provides support. This brace is to be welded under the mid section of the rear cargo area. Approximate size is 35.75″ long by 3.00″ wide. This brace fits side to side and requires welding...

Firewall lower brace, LH 1966-73 Jeepster/Command

Firewall lower brace, LH 1966-73 Jeepster/Commando This part is on driver side of the lower firewall. It connects to the right body frame braces and the lower firewall section where it meets the underside of the floor board. The left and right are...