Engine

Timing cover and water pump master bolt kit, 225/231 V6

Timing cover and water pump master bolt kit This includes all the bolts and washers needed to install a new timing cover and water pump Be  sure to chase all threads with bottoming tap and use air to fully blow out holes. Use sealant where...

Timing cover bolt kit, 225/231 V6

Timing cover bolt kit, 225/231 V6   All the bolts you need to install a new timing cover. This kit even includes the alternator tension arm bolt and the timing pointer bolt and washer if you are using an aftermarket timing cover Make sure you...

Water pump grade 8 bolt kit

Water pump bolt kit for 225/231 V6 All the bolts you need to replace your water pump. This kit even come with the bolt/washer for the alternator bracket. Be  sure to chase all threads with bottoming tap and use air to fully blow out holes...

Timing chain damper special bolt, 225 V6

Timing chain damper special bolt. This is the pivot bolt that the damper spring rides on. These can get worn out and affects the tension on the timing chain. #24 in the diagram

Prestolite ignition rotor, oddfire 225 V6

Prestolite ignition rotor for oddfire 225 V6

Prestolite distributor cap, 225V6

Prestolite distributor cap for oddfire 225V6

Head bolt set, ARP 225/231 V6

Head bolt kit, ARP for 225/231 V6

Front crankshaft cover seal, F/L head 4-134

Front cover crankshaft seal Fits: Willys MB (1941-1945) w/ 4-134 L-Head engine. Willys M38 (1950-1952) w/ 4-134 L-Head engine. Willys M38-A1 (1952-1963) w/ 4-134 F-Head engine. Jeep CJ-2A (1945-1949) w/ 4-134 L-Head engine...

Distributor, electronic ignition 12V only 4-134 engine

4-134ci electronic ignition distributor, brand new!! Ditch those points and condensers, get with it! Easier starts, better mileage and more power! Fits:Willys MB (1941-1945) w/ 4-134 L-Head engine.Willys M38 (1950-1952) w/ 4-134 L-Head engine.Willys...

Heater hose fitting, 1/2" NPT x 5/8" barbed, straight

Heater hose fitting, 1/2" NPT x 5/8" barbed, straight

Heater hose fitting, 3/8" NPT x 5/8" barbed, straight

Heat hose fitting, 3/8" NPT x 5/8" barbed, straight

Heater hose fitting, 1/2" NPT x 5/8" barbed, 90 degree

Heater hose fitting, 1/2" NPT x 5/8" barbed, 90 degree