1955-86 JEEP CJ5/CJ6

Side arm mirror kit with 5" round mirror

Reproduction of common side mirror for many models   Vehicle Applications 1943-1945 Jeep Willys 1946-1949 Jeep Willys CJ-2 1950-1955 Jeep Willys CJ-3 1957 Jeep Willys CJ-3 1951-1952 Jeep Willys CJ-3 Chassis 1955-1956 Jeep Willys CJ-5 1958...

Wire Harness, Universal 21 circuit pre labled wires

21 Circuit generic universal wire harness These wiring kits use GXL 125 high temp cross linked polyethylene jacketed wire that is grease, oil, gas, and acid resistant. Each wire is labeled every 5" its entire length so checking a circuit is easy! COLOR...

Differential race, Dana 25

Dana 25 front differential race Fits: Willys MB (1941-1945) w/ Dana 25 Front Axle. Willys MB (1941-1945) w/ Dana 27 Rear Axle. Willys M38 (1950-1952) w/ Dana 25 Front Axle. Willys M38-A1 (1952-1963) w/ Dana 25 Front Axle. Jeep...

Distributor drive gear, 225/231 V6

Distributor drive gear for 225/231 V6 with HEI distributor This will also fit the Delco distributor, but you will have to drill out the distributor shaft to accomodate the included larger roll pin. No drilling on HEI appliaction

Differential side gear washer, Dana 44 flanged/Dana 53

Fits Jeep: Jeep Wrangler (YJ) (1987-1995) w/ Dana 44 Rear Axle; KDX. Jeep Cherokee (XJ) (1984-1993) w/ Dana 44 Rear Axle. Jeep Comanche (MJ) (1986-1992) w/ Dana 44 Rear Axle. Fits Vintage Jeep: Jeep CJ-5 (1969-1975) w/ Dana...

Clutch for pivot ball, extended

Clutch fork pivot ball, extended .30" to account for clutch fingers that do not protruded into the throwout bearing as much as the older clutches used to. This will correct the geometry. Measures 1.80" in length.   This will not work for one-piece...

Twin stick conversion for 1965-71 Jeep CJ5/6

Single to Dual Stick Transfer Case Conversion Kit This kit converts your later style single stick D18 transfer case to the twin stick conversion of earlier Willys. Application:Dana 18 transfer case Kit Includes:Transfer Case Dual Shift Levers (2)Black...

Dana 20 twin stick shifter, Jeep CJ 1972-79 manual transmission

  This shifter fits the Jeep CJ Dana-20 transfer case that has the stock shifter mounted right up against the transfer case, and a straight shift pattern, typically stock 3-speed applications...

Side mirror arm and mounting bracket

Side mirror ar and bmnounting bracket, made in the USA!

Hose line fitting, -3AN Male to 3/8"-24, Female

Hose Line Fitting, 3an Male to 3/8"-24, Female   These are commonly used for front brake line fitment issues. Most stainless extended brake line kits are made for 11" brakes which typically have 1/2"-20 flare nuts on the hard lines...

Inner wheel bearing/race for Dana 30/44 with disc brakes

Inner wheel bearing/race set for disc brake Dana 30/44 spindle

Fuel Tank, 1955-71 CJ under the seat

Fuel Tank, 1955-71 CJ under the seat  1955-1972 Jeep® CJ 5 and CJ 6. This is an under the "drivers" seat gas tank with a 6 screw sending unit hole and an angled filler pipe. The pickup tube comes installed on the top of the tank...