1947-1965 WILLYS PICKUP

Bullet connector, 3 way

3 way bullet connector, 3 separate in, 3 separate out. These are used in Jeeps from 1946-1986

Bullet connector, 2 way

2 Way bullet connector. You will find these all over your Jeep, connects two male bullets. Stock up, you will need more than you think! These come with 2 new male bullets so you can have an all new connection!

Hub puller for tapered axles

Hub puller needed to pull hubs off tapered axles. These are not he cheapie version that typically break before you can finish the job. These are quality made pullers that you will have for a lifetime. 

King pin rebuild kit, Dana 25/27/44

New King Pin bearing kit for both sides. Includes 4 bearings, 4 races, and new, made in the USA shim pack with 30 shims (competitors have about 13-15) Fits: Dana 25/27 Fits: 41-45 MB 45-45 GPW 46-49 CJ-2A 49-53 CJ-3A 53-64 CJ-3B 55-71...

Hood latch, stainless steel set

Hood holdown set, stainless steel

Fuel sender adapter, 6 bolt to 5 bolt aftermarket pattern

It's easy to use an aftermarket 5 hole sending unit in your car or truck that has a big 6 hole sending unit with our adapter. Our high quality machined T6061 billet aluminum fuel tank adapter adapts the 6-hole pattern to the aftermarket 5-hole pattern...

Warn overdrive or single lever shifter boot/retaining ring/stainless hardware

Shift boot for Warn/Saturn overdrive with retaining ring and stainless hardware. Nice supple shifter boot to fill in that hole!

Shackle kit, Heavy Duty for (2) 1-3/4" wide springs w/ greasable bolts

Fits: Jeep CJ-3B (1953-1968); Front or Rear. Jeep CJ-5 (1955-1975); Front or Rear. Jeep CJ-6 (1955-1975); Front or Rear. Jeep Pickup (1947-1965); Front. Jeep Sedan Delivery (1948-1963); Front. Station...

Wire Harness, Universal 21 circuit pre labled wires

21 Circuit generic universal wire harness These wiring kits use GXL 125 high temp cross linked polyethylene jacketed wire that is grease, oil, gas, and acid resistant. Each wire is labeled every 5" its entire length so checking a circuit is easy! COLOR...

Differential race, Dana 25

Dana 25 front differential race Fits: Willys MB (1941-1945) w/ Dana 25 Front Axle. Willys MB (1941-1945) w/ Dana 27 Rear Axle. Willys M38 (1950-1952) w/ Dana 25 Front Axle. Willys M38-A1 (1952-1963) w/ Dana 25 Front Axle. Jeep...

Differential side gear washer, Dana 44 flanged/Dana 53

Fits Jeep: Jeep Wrangler (YJ) (1987-1995) w/ Dana 44 Rear Axle; KDX. Jeep Cherokee (XJ) (1984-1993) w/ Dana 44 Rear Axle. Jeep Comanche (MJ) (1986-1992) w/ Dana 44 Rear Axle. Fits Vintage Jeep: Jeep CJ-5 (1969-1975) w/ Dana...

Hose line fitting, -3AN Male to 3/8"-24, Female

Hose Line Fitting, 3an Male to 3/8"-24, Female   These are commonly used for front brake line fitment issues. Most stainless extended brake line kits are made for 11" brakes which typically have 1/2"-20 flare nuts on the hard lines...