1966-71 JEEPSTER/COMMANDO

Brake hose pair for disc brakes, stainless steel, 7/16" banjo

Braided Stainless Steel Brake Hose 7/16 Diameter  Banjo bolts & crush washers included 18" long Set of 2 3/8-24 IFF fitting to hard line.

Brake calipers, loaded for caliper mounts CB7191

GM 7" Large Single Piston Caliper Set Pre Loaded with pads Caliper Pins Included Cast Iron Finish Sold as a set Left (4045) & Right (4046) Single Piston 1974-1978 Jeep Cherokee, Wagoneer, J10, J201971-1978 Chevrolet K10, K20, K5 Blazer, K10...

Disc Brake conversion, 25/27/30/44, thick rotors

Fits 25, 27, 30 & 44 original front drum knuckles Single large piston calipers pre-loaded with pads 11" a 1-1/8" thick standard vented rotors, 5 on 5.5" bolt pattern Caliper brackets Rubber brake hoses Installation hardware Lug...

Dana 25/27/30/44/53 outer pinion bearing

Timken outer pinion bearing for Dana 25/27/30/44/53. Bearing only   Fits Jeep: Jeep Wrangler (TJ) (1997-2006) w/ Dana 44 Front or Dana 44 Rear Axle. Jeep Wrangler (YJ) (1987-1995) w/ Dana 30 Front or Dana 44 Rear Axle. Jeep Cherokee...

Dana 25/27/30/44/53 outer pinion bearing race

Timken Pinion bearing race, Dana 25/27/30/44/53 Fits Jeep: Jeep Wrangler (TJ) (1997-2006) w/ Dana 44 Front or Dana 44 Rear Axle. Jeep Wrangler (YJ) (1987-1995) w/ Dana 30 Front or Dana 44 Rear Axle. Jeep Cherokee (XJ) (1984-1999) w/...

Valve cover gasket set, 225 V6

Improved cork valve cover gaskets for 225 V6

Steering stabilizer kit

Steering stabilizer kit Multiple mounting options for manual or power steering.

Nylon fuel line kit, V6

Stock replacement nylon fuel lines from the tank to the back of the engine where it connects to the steel fuel lines that goes to the fuel pump on V6 applications. # 37 and#38 in the diagram   Kit includes: 100" 1/4" nylon vent line 100" 5/16"...

Passenger seat hold down latch and hood safety catch

Passenger seat hold down latch. These are either NOS or militart take outs, pristine

Exhaust System, Jeepster/Commando in stainless

1967-71 Jeepster/Commando/C101 V6 225 Stainless Single Exhaust Single exhaust system included Y pipe, muffler and tailpipe.Photo depicts a 1967-71 Jeep Commando / Jeepster C101.For systems requiring 2" (and up) pipes, we use 14 gauge stainless steel...

Exhaust System, Aluminized C101

1967-71 Jeepster/Commando/C101 V6 225 Aluminized Single Exhaust   Complete Single exhaust system includes Y pipe, muffler and tailpipe.Photo depicts 1967-72 Jeep Commando / Jeepster C101.For systems requiring pipes 2" and up, we use 14 gauge...

Ignition switch connector housing, deluxe kit

Ignition switch housing with new spade terminals. This is the plug that goes into your ignition switch. These get burn out and cracked, causing all kinds of problems. Simply remove old plug, trim back old terminals (very minimal) install new...