Electrical / Instruments

Antenna, spring base cowl mount

Spring base antenna with adjustable base. 

2 into 1 electrical connector with bullet connectors

2 into 1 electrical connection with bullet connectors.  Jeep used these all over the place for marking lights, tail lights, dash and wherever they needed 1 into 2.  These come with properly sized bullet connectors to  make your job quick...

2 hole dash panel loaded with gauges, black or white faces available

2 hole dash plate with Dolphin quad gauges, speedometer, sending units, mounting bolts, 2 green turn lights and 1 high beam indicator light.  Made from a template of the exact opening of the dash, cut on a water jet cutter. Four 8/32"...

3 Hole dash panel loaded with gauges, black or white faces available

3 hole dash plate with Dolphin quad gauges, speedometer and tachometer, sending units, mounting bolts, 2 green turn lights and 1 high beam indicator light.  Made from a template of the exact opening of the dash, cut on a water jet...

Horn, Low pitch, 12V

Horn, low pitch, 12V, generic

Horn, High pitch, 12V

Horn, low pitch 12V generic horn.

Ignition coil, 12V

12 volt ignition coil

Tail light socket repair pigtail, Single pin

Single pin repair pigtail for common tail light housings. This is for the 1156 style bulb, backup light single pin   Double pin is also available #TLRK5221

Tail light socket repair pigtail, double pin

Double pin repair pigtail for common tail light housings. This is for the 1157 style bulb, tail and brake/turn   Single pin is also available #TLRK5220

Firewall grommet assembly

Firewall grommet assembly. Replace those old crumbling rubber grommets and rusty rings with BRAND NEW!! Our own reproduction of the firewall grommet with the retainer and screws. This grommet is made like the original with the large 9/16" hole in the...

Ignition switch connector housing, deluxe kit

Ignition switch housing with new spade terminals. This is the plug that goes into your ignition switch. These get burn out and cracked, causing all kinds of problems. Simply remove old plug, trim back old terminals (very minimal) install new...

No hole dash plate with mounting hardware

No hole dash plate made from a template of the exact opening of the dash, cut on a water jet cutter.  What's different on the plate id it is not a rectangle, this plate fits the exact contour of the cut out on your dash Four 8/32" stainless steel...