1950-1952 Jeep M38 (MC)

Firewall grommet assembly

Firewall grommet assembly. Replace those old crumbling rubber grommets and rusty rings with BRAND NEW!! Our own reproduction of the firewall grommet with the retainer and screws. This grommet is made like the original with the large 9/16" hole in the...

Steering box mounting bracket kit

Brand new cast steering box bracket. Exact reproduction of factory bracket. This bracket was used on the 69-71 Jeepster Commando, but is universal to those wishing to convert to Saginaw steering. This bracket mounts to the frame rail on the driver...

Residual Valve, 10lb drum brakes

Universal Residual Check Valve, 10 lbs. A residual valve acts like a one-way or check valve to maintain brake system pressure to eliminate the problems of a spongy pedal. This 10 PSI residual valve is installed inline...

Brake hose pair for disc brakes, stainless steel, 7/16" banjo

Braided Stainless Steel Brake Hose 7/16 Diameter  Banjo bolts & crush washers included 18" long Set of 2 3/8-24 IFF fitting to hard line.

Disc brake conversion, thick drilled and slotted rotors, Dana 25/27/30/44

Fits 25, 27, 30 & 44 original front drum knuckles Single large piston calipers pre-loaded with pads 11" a 1-1/8" thick drilled and slotted vented rotors, 5 on 5.5" bolt pattern Caliper brackets Rubber brake hoses Installation hardware Lug...

Disc Brake conversion, 25/27/30/44, thick rotors

Fits 25, 27, 30 & 44 original front drum knuckles Single large piston calipers pre-loaded with pads 11" a 1-1/8" thick standard vented rotors, 5 on 5.5" bolt pattern Caliper brackets Rubber brake hoses Installation hardware Lug...

Universal under dash swing pedal assembly

Mounts under the dash and completely adjustable. This requires some fabrication skills to install, as each vehicle is a little different in spacing and room under the dash. Laser cut and powder coated black Works with manual or power...

Dana 25/27/30/44/53 outer pinion bearing

Timken outer pinion bearing for Dana 25/27/30/44/53. Bearing only   Fits Jeep: Jeep Wrangler (TJ) (1997-2006) w/ Dana 44 Front or Dana 44 Rear Axle. Jeep Wrangler (YJ) (1987-1995) w/ Dana 30 Front or Dana 44 Rear Axle. Jeep Cherokee...

Dana 25/27/30/44/53 outer pinion bearing race

Timken Pinion bearing race, Dana 25/27/30/44/53 Fits Jeep: Jeep Wrangler (TJ) (1997-2006) w/ Dana 44 Front or Dana 44 Rear Axle. Jeep Wrangler (YJ) (1987-1995) w/ Dana 30 Front or Dana 44 Rear Axle. Jeep Cherokee (XJ) (1984-1999) w/...

Steering stabilizer kit

Steering stabilizer kit Multiple mounting options for manual or power steering.

U Bolt set for driveline u-joint

U Bolt kit for driveline u-joints The kit does one u-joint (one end of drive shaft)

Snaps, male stainless steel with #8 sheet metal screw stud, each

Stainless steel male stud snap, #8 sheet metal stud.