Suspension

Spring plate, 2" wide front spring, RF

Fits: Jeep CJ-5 (1976-1983) Jeep CJ-7 (1976-1986) Jeep CJ-8 (1981-1986) Jeep Commando (1972-1973) You can either leave the stabilizer stud or cut it off   RF 2" Leaf Spring Plate; Includes Stabilizer Link Stud. Dana 30

Shock stud, threaded

Generic shock stud. You can replace a bent or broken stud by welding this in place or thread it in to a nut. Replace the early cotter pin shock stud with these to eliminate the frustration! Can add to spring plate for dual shocks or a sway bar end...

Sway bar rebuild kit

Sway bar rebuild kit. All you need to rebuild and restore your factory sway bar bushings

Sway bar to frame bushing

Sway bar to frame bushing, 13/16" ID.

Spring bushing, 2" spring shackle pivot end

Front spring bushing for pivot (shackle) end for 2" springs found on late 1969 to 1973 Jeepster/Commandos    

U-Bolt HD multi leaf 1/2" x 7"

Fits: Willys M38-A1 (1952-1963) w/ Dana 44 Rear Axle. Jeep CJ-3A (1948-1953) w/ Dana 44 Rear Axle. Jeep CJ-3B (1953-1968) w/ Dana 44 Rear Axle. Jeep CJ-5 (1955-1975) w/ Dana 44 Rear Axle. Jeep CJ-6 (1955-1975) w/ Dana 44...

Shock, sway bar link lower or panhard bar one piece bushing

Bushing for sway bar link on the lower eye end, shocks or panhard bar end bushings. One piece design like modern shock bushing 5/8" ID

U Bolt, Front large one

Front end large u bolt that goes over front differential housing. Need one per vehicle.   Fits: Willys MB (1941-1945). Jeep CJ-2A (1945-1949). Jeep CJ-3A (1948-1953). Jeep CJ-3B (1953-1968). Jeep CJ-5 (1955-1975)...

U bolt, front and rear (not the large front one)

U bolt for front and rear ends. This is the one that goes over the axle tube, not over the front differential housing (#808988). Come with nuts and washers. You need 7 total,  3 for the front and 4 for the rear to complete replacement (and 1...

Ball joint kit, Dana 30/44, one side

Ball joint kit for open knuckle Dana 30 front end. Both upper and lower ball joints with all the hardware to replace the ball joints. This kit does one side.  Black boots (blue shown in picture is just shipping protector for the...

Spring Shackle Front 2"

Front Spring shackle for Jeepster with 2" front Springs. Please measure before ordering, as this was a late change in '70-'71 through '73 for the Jeepster. Fits: Jeep CJ (1976-1986); Front. Jeepster (Late 70-71 to 73) Please measure spring

Drop pitman arm manual Saginaw

3 1/2" drop down pitman arm.  Fits the following Jeepster with manual Saginaw steering gearbox 1970-1971 Jeepster Commando 1972-1973 Jeep Commando 1984-1993 Jeep Cherokee (XJ)