1955-86 JEEP CJ5/CJ6

Pertronix Flame thrower coil - 40,000 Volts

Pertronix Flame thrower coil 40,000 volt!   This is the ideal coil with the electronic ignition conversion #1165 for the 225 V6

Dana 18/20 shift rail seals

Dana 18/20 shift rail seals   Fits: Willys MB (1941-1945) w/ Dana 18 Transfer Case. Willys M38 (1950-1952) w/ Dana 18 Transfer Case. Willys M38-A1 (1952-1963) w/ Dana 18 Transfer Case. Jeep CJ-2A (1945-1949) w/ Dana 18...

Dana 25/27/44 pinion set up shim kit

Dana 25/27/44 pinion set up shims Fits: Willys MB (1941-1945) w/ Dana 25 Front Axle. Willys MB (1941-1945) w/ Dana 27 Rear Axle. Willys M38 (1950-1952) w/ Dana 25 Front Axle. Willys M38-A1 (1952-1963) w/ Dana 25 Front Axle...

Intermediate shaft kit, 1-1/8"

Intermediate shaft kit Fits: Willys M38 (1950-1952) w/ Dana 18 Transfer Case. Willys M38-A1 (1952-1963) w/ Dana 18 Transfer Case. Jeep CJ-2A (1945-1949) w/ Dana 18 Transfer Case. Jeep CJ-3A (1948-1953) w/ Dana 18 Transfer Case...

Glass mounting rubber tape

Glass mounting rubber tape Originally meant for Jeep SJ tailgate glass, but works to set window glass into window frame channels for all types of rollup windows.   This can also be used as a gasket in mounting sliding hardtop windows and upper...

Clutch pivot and bracket

Clutch pivot stud and bracket Fits: Jeep CJ-5 (1976-1983) w/ LHD; w/ 4.2L engine. Jeep CJ-5 (1976-1981) w/ 4.2L engine. Jeep CJ-7 (1976-1986) w/ LHD; w/ 4.2L engine. Jeep CJ-7 (1976-1981) w/ 4.2L engine. Jeep...

Front wheel bearing outer nut

Front wheel bearing outer nut Fits: Jeep SJ & J-Series (1974-1991). Goes with: Inner nut with pin, see # 4004816 Slotted washer, see # 4004815

Front wheel bearing inner nut

Wheel hub inner nut with locking pin Fits: Jeep SJ & J-Series (1974-1991).   Washer available, see# 4004815 Outer nut available, see # 5352169

Front wheel bearing washer

Front axle wheel hub washer Fits: Jeep SJ & J-Series (1974-1991). Nuts sets are also available, see# 4004816

T90 reverse idler gear

T90 reverse idler gear Fits: Willys M38 (1950-1952) w/ T90 Transmission. Willys M38-A1 (1952-1963) w/ T90 Transmission. Jeep CJ-2A (1945-1949) w/ T90 Transmission. Jeep CJ-3A (1948-1953) w/ T90 Transmission. Jeep...

Hub gasket, early scalloped outside

Hub gasket for early Dana 25/27 with scalloped outside edges

Left rear spring plate, Dana 44 LH with 2-1/2" wide spring

Left rear spring plate, Dana 44 with 2-1/2" wide rear springs   Fits: Jeep CJ-5 (1976-1983). Jeep CJ-7 (1976-1986). Jeep CJ-8 (1981-1986). This will fit most Dana 44's with 2-1/2" rear springs, you might have to swap side to...